Arrogant Bastard Ale Onion Rings

[Photograph: Studio Schulz]

While most beer batters assume that any fizzy, flavorless swill will do, these onion rings were created to highlight the big-flavored, boozy brew that Stone Brewing Co. is known for.

Reprinted with permission from The Craft of Stone Brewing Co. by Greg Koch and Steve Wagner with Randy Clemens. Copyright © 2011. Published by Ten Speed Press. Available wherever books are sold. All rights reserved.

Loading text goes here What's This? OK

Arrogant Bastard Ale Onion Rings

About This Recipe

Yield:6 to 8
Active time:30 minutes
Total time:30 minutes
This recipe appears in: Cooking With Beer: Arrogant Bastard Onion Rings

Ingredients

  • 4 very large yellow onions
  • 1 recipe Arrogant Bastard Ale Batter (recipe 
follows)
  • Vegetable oil, for frying
  • Kosher salt
  • Arrogant Bastard Ale Batter
  • 2 cups (16 fluid ounces) cold Arrogant Bastard Ale
  • Heaping 3/4 teaspoon Cajun spice blend
  • Heaping 1/2 teaspoon kosher salt
  • 1/2 teaspoon ground dried chipotle chiles
  • 1/2 teaspoon smoked paprika
  • 1/2 teaspoon granulated garlic
  • About 1 cup (4 ounces) all-purpose flour
  • 1 teaspoon baking powder

Procedures

  1. 1

    Arrogant Bastard Ale Batter: Pour the Arrogant Bastard Ale into a high-sided narrow container. Stir in the Cajun spice blend, salt, chipotle, smoked paprika, and garlic. Sift the flour and baking powder together, then add them to the beer mixture slowly, whisking well until they’re evenly and thoroughly incorporated. You may need a bit more or less flour to reach the ideal consistency for a tempura-style batter. It should be just thick enough to coat whatever you’re frying.

  2. 2

    Cut off the ends of each onion, cut in half crosswise (around the equator), and remove the papery skin and thin outer membrane. Soak in a bowl of ice water for 10 minutes.

  3. 3

    Drain the onions, separate the concentric rings, and spread them on a kitchen towel to dry.

  4. 4

    Preheat the oven to 200°F. Prepare a deep fryer, filling it with oil to the manufacturer’s suggested fill level. Alternately, use a wide cast-iron or other heavy-duty pan that’s at least 4 inches deep, pouring in oil to a depth of 
2 to 3 inches, and no more than halfway up the side of the pan. Heat the oil to 360°F.

  5. 5

    Dunk the onion rings in the batter and fry in batches until crispy and deep reddish brown, 4 to 6 minutes. Be careful not to overcrowd the pan, as this will lower the temperature of the oil significantly and result in soggy onion rings. Transfer cooked onion rings to a wire rack set over a baking sheet (or directly on a parchment paper-lined baking sheet). Season with a sprinkling of salt and keep them in the oven until the entire batch has been fried.

  6. 6

    Serve hot, with a side of BBQ sauce for dipping. (No ketchup!)

Comments

Add a rating with your comment:

Comments can take up to a minute to appear - please be patient!

Previewing your comment: